Skip to content

Straight talk about your car's repair, like a neighbor

(559) 468-3243
(559) 468-3243

ServicesDent Repair

Dent Repair in Kerman

Door dings, hail marks and the crease from a runaway shopping cart all get the same careful look at our shop. When the paint is unbroken, we work the metal back from behind and keep the factory finish. When it isn't, we explain why and what the repair takes.

Technician kneeling beside a gray sedan's front door, working a dent with hand tools under a tripod LED light board, with dent rods on the shop wall.

Two ways to fix a dent, and how we pick

Most dents can be fixed one of two ways. Paintless dent repair uses steel rods and specialty lights to massage the panel back into shape from behind, with no filler and no new paint. Conventional dent repair pulls or taps the metal close to shape, adds a thin skim of body filler, then primes and paints the area to match.

The paint decides a lot. If it is cracked, chipped or stretched too far, paintless work can't hide it, and pushing the metal can make a crack worse. Sharp creases, dents on a body line and damage near a panel edge are also harder to fix without refinishing. We look closely before recommending anything, and we treat your car the way we'd want a neighbor to treat ours. Sometimes that means telling you a small ding can wait.

If the dent came from a bigger hit, the work may really belong under collision repair, and we'll say so.

What dent repair at our shop covers

A close look under good light

We inspect the dent with a reflection board so we can see its true size, any stretched metal and whether the paint has cracked. We point out what we find so you can see it too.

Paintless removal from behind

Where we can reach the back of the panel, we remove trim, inner liners or tail lamps as needed and work the metal out slowly. Done right, there is no filler and no paint to match.

Glue pulling for hard-to-reach spots

Roof rails and double-walled areas often block tool access. We bond pull tabs to the surface, draw the dent out from the outside, then clean the glue off.

Filler, primer and paint when needed

For creased or torn paint, we straighten the metal first so the filler layer stays thin, then prime, block sand and refinish. Our Paint and Refinishing page covers color matching and blending in more detail.

Hail damage

Hail can leave dozens of shallow dents across the hood, roof and trunk. We map every one before starting and work through each panel in order.

Reassembly and a final check

Every clip, liner and light we removed goes back where it came from. At pickup we walk around your car with you and show you the repaired area.

Signs a dent is worth bringing in

  • Cracked paint at the edge

    Cracked paint lets moisture reach bare steel. Rust can start under the finish and spread, so even a small crack is better fixed sooner.

  • A crease along a body line

    Dents on a sharp body line are harder to repair the longer the metal sits stressed. An early look keeps paintless options open.

  • A door that closes differently

    If a dented door now rattles, sticks or needs an extra push, the damage may go past the outer skin. We check the hinges and inner structure and explain the next step if it's more than a dent.

  • Small dents after a storm

    Hail and falling branches leave shallow dents you may only notice in low sunlight. They don't improve on their own and are easier to document for an insurance claim right away.

  • Selling or trading in your vehicle

    Dents pull down a trade-in offer. A clean paintless repair before an appraisal can cost less than the hit you'd take on the price.

How a dent repair visit goes

  1. 1

    Call and describe the damage

    Tell us where the dent is, roughly how big it looks and whether the paint is broken. We'll set a time for you to bring your car in.

  2. 2

    Inspection and a written estimate

    We study the dent under light, check access behind the panel and write an estimate that lists the method and each step. If a ding isn't worth fixing, we tell you that plainly.

  3. 3

    The repair

    Small paintless repairs are usually short jobs. Repairs that need paint take longer because primer and paint need time to cure, and we give you a realistic timeline up front.

  4. 4

    Pickup and walk-around

    We show you the finished panel in good light and answer your questions before you drive off.

What affects the cost of dent repair

We price dent repair by what the dent actually needs, not a flat rate per ding. Two dents the same size can take very different amounts of work. The estimate explains why yours costs what it does.

Size and depth
A shallow dent the size of a coin takes less time than a deep one the size of a fist. Deep dents stretch the metal, and stretched metal resists going back.
Location on the panel
Dents on body lines, panel edges or roof rails take more time and skill. Access matters too, since we may need to remove trim or liners to reach the back.
Condition of the paint
Unbroken paint usually means a paintless repair. Cracked or chipped paint adds filler, primer, paint and blending into the panels next to it.
Panel material
Aluminum hoods and panels, common on newer trucks and SUVs, are stiffer and less forgiving than steel and call for slower work.
Number of dents
Hail damage is estimated dent by dent and panel by panel, so a car with a few dozen marks costs more than one with a single ding.

Dent repair questions we hear often

Something not covered here? (559) 468-3243

Can you fix my dent without painting?

Often, yes, if the paint isn't cracked and we can reach the back of the panel or pull from the front. Sharp creases and stretched metal sometimes need filler and paint to look right. We'll tell you which applies once we see it.

Will the repaired spot look different from the rest of my car?

With paintless repair the original finish stays in place, so there is nothing to match. When paint is needed, we blend the new color into the surrounding panel so the edge doesn't show in bright sun.

Should I go through insurance for a dent?

It depends on your deductible and how much damage there is. For one small ding, paying directly is often simpler. For hail or several panels a claim may make sense, and our Insurance Claims page explains how we work with your insurer.

How long will you need my car?

That depends on the method and the number of dents. A single paintless repair is usually a short job, while painted repairs need curing time. You'll get an honest timeline along with the estimate.

Can an old dent still be fixed?

Usually. Older dents get harder if the paint has since cracked or rust has started, but many still push out cleanly. If we find rust, we treat it before any refinishing.

Gray SUV parked on a wet concrete lot outside a metal body shop, with open bays, a masked car ready for paint, and a front-damaged car nearby

Let us take a look at that dent

Give us a call, bring your car by, and we'll show you what the dent needs in plain terms. We help drivers in Kerman and nearby towns like San Joaquin and Mendota.